1. Sort the panel measures by specifications and sizes. Surfaces of face panels and side panels shall be selected, and handle the panels gently.
2. Customize the panels with the largest number in width;
3. Use the flat drill and vertical drill to finish all large flat buckles firstly. After finishing drilling, the operations above can be used to adjust the measure after adjusting the drilling position;
4. The measure can be fixed by moving leftwards or rightwards taking with the width of the two lateral panels of the drawer as the size benchmark; The thick slabs of two lateral panels are jointed and placed in the middle for punching, and both the left and right measures of the drawer panel will be increased by 10mm and then placed on the platform for punching;
5. Put all panels on the trolley with nothing left after punching, and then put them together by sizes.
6. Turn off the multi-drill power supply and blow off the saw dust on the machine;
7. Carry out a self-inspection every time activate the measure or replace the drill or switch drilling button; press the emergency button immediately to shut down the machine in case of any abnormity.
II. The multi-drill factory should pay attention to issues below when using the machine:
The user should beware of some problems when using the woodworking multi-drill, in which, the correct right is of critical importance, and it is also a safety issue in use. Therefore, we must be cautious about the use of the multi-drill. And we also need to protect the drill reasonably, because it is very important for multi-drill. Vibrational collisions shall also be avoided when using woodworking multi-drill. Too strong multi-drill vibration will incur a great impact on the processing precision when controlling the multi-drill, by which, disqualified products are produced at a high rate. Therefore, we should keep every part of the multi-drill well in daily use, and we should avoid the unnecessary machine damage to the parts. We should perform microscopy processing on some components with very high precision requirements when using woodworking multi-drill for part machining, by which, error occurrence of woodworking multi-drill may be significantly reduced. Certain position precision is necessary at the installation of woodworking multi-drill, in which, our precision should be adjusted and determined based on the product demand.
Correct Use of Woodworking Multi-drills of Factories
1. Please read the instructions carefully before operating this machine. Check whether the ground wire is securely grounded, whether the components are normal, and whether the operating position is bright (untrained personnel should not operate the machine).
2. Do "three tight", "three no", and "one attention" during operation. "Three tight": tight clothing, tight waist, and tight sleeves; "Three no": no tie, no jewelry, no gloves; "One attention": Pat attention to protecting your eyes.
3. Please pay attention to the indication of all warning signs before starting the machine.
4. Make sure about the rotation direction of the drill and select it correctly.
5. Do not get close to or contact the moving or rotating components and parts.
6. Asynchronous working must be selected if interference occurs between horizontal drilling and vertical drilling.
7. Do not adjust or repair the machine until the main power is turned off.
