-
Four Preparations and Start-up Preparati...
2019-10-09761Firstly, clean up the machine and work site; Secondly, check if the vacuum system is normal; Then check whether the sliding table saw blade is sharp; Check whether the saw blades in different sizes are in a straight line; Test the machine for about one minute to check whether the machine can run normally; Finally, prepare the materials and accessories.
-
Installation Procedures of Automatic Edg...
2019-10-09925It is necessary to check whether the ground is strong and flat before installing the automatic edge banding machine, and it is optimal to install it on the concrete surface to ensure the stability after setting.
-
Simple Analysis of Factories on Correct ...
2019-10-091385Sort the panel measures by specifications and sizes. Surfaces of face panels and side panels shall be selected, and handle the panels gently.
-
Effect of Gas Pressure on Cutting Qualit...
2019-10-09682For that purpose, we require the personnel operating the CNC cutting saw to observe the output pressure display of the air compressor before use, and adjust it in time (if any inconformity) to save raw materials and time.
-
Notes on Use of Hinge Drilling Machine
2019-10-091221In order to protect the hinge drilling machine and achieve the optimal working effect in use, we should pay attention to some instructions. Firstly, the right drill or bit shall be selected according to the target object. The corresponding drilling rate shall be selected according to the target object.